Skip to content

Back from Vertical Pro 2026

Two days in Friedrichshafen, hall A5, stand 704: we presented the new control panel.

Mit der Fähre über den Bodensee im Morgenlicht

An early start in Biel, the ferry across Lake Constance just as it was getting light, and then two days of Vertical Pro in Friedrichshafen. Now we’re back and sorting through our impressions.

Setting up

Banner up, posters on the wall, device and control panel in place. Our stand in hall A5 was small, but the most important thing was there: the eClimber with its new control panel.

Setting up: posters above the banner «Makes climbing accessible.»

New: the control panel

At the fair we presented the new control panel. Right next to the wall you set the support with plus and minus, start the climb and see height, time and support at a glance. How to use the eClimber

Unfortunately, climbing wasn’t possible at the stand. Instead, a demo with a 40 kg weight ran on the tower, and with your hand on the rope you could feel how quickly and finely the eClimber reacts: high, good dynamics you can touch. In total the eClimber did 2000 cycles at the fair, lifting the weight 1 m each time, without a single fault or incident. The motor takes off up to 100 kg, the mechanics do the belaying. See the eClimber

The eClimber with the new control panel at the stand

Thank you to everyone who stopped by. We’re taking lots of good conversations and new ideas back to Biel.

What’s next

Would you like the eClimber in your gym? The guide Buying or renting the eClimber covers prices, the test phase and installation. Or would you like to sell the eClimber as a dealer? Get in touch at info@eclimber.ch, we’d love to hear from you.

Your eClimber team

← All posts